Flex FWD V6-3.5L (2010)
15. If equipped, install the manual lumbar cable into the adjuster.
16. Route and attach the wire harness and cable retainers in the following sequence.
1. Attach the outboard fold-flat cable and cover to the recliner.
2. Route and attach the side air bag module wire harness pin-type retainers.
3. If equipped, install the manual lumbar cable cover into the adjuster.
4. If equipped, install the manual lumbar cable retainers.
17. NOTE: Manual track shown, power track similar.
Route the side air bag module wire harness under the seat.
18. Position the cushion cover flap back around the side of the seat, attach all the outboard cushion cover J-clips and install the pin-type retainer.
19. Seats with manual seat track, connect the electrical connector and attach the pin-type retainers under the seat. For correct passenger seat wire
harness routing, refer to Seat Wire Harness Routing See: Service and Repair/Seat Wire Harness Routing.
1. Connect the side air bag module electrical connector and slide the locking clip to the lock position.
2. Route the wire harness and attach the side air bag module electrical connector and wire harness retainers.
20. Seats with power seat track, connect electrical connectors and attach the pin-type retainers under the seat. For correct passenger seat wire harness
routing, refer to Seat Wire Harness Routing See: Service and Repair/Seat Wire Harness Routing.
1. Connect the side air bag module electrical connector and slide the locking clip to the lock position.
2. Connect the backrest feed electrical connector.
3. Route the wire harness and attach the connectors and wire harness retainers.