Flex FWD V6-3.5L (2010)
-
Measure the resistance between the SASM C2412-4, circuit GD114 (BK/BU), harness side and ground.
-
Is the resistance less than 5 ohms?
Yes
GO to H3.
No
REPAIR the circuit. CONNECT the negative battery cable. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
H3 CHECK THE HS-CAN CIRCUITS BETWEEN THE SASM AND THE DLC FOR AN OPEN
-
Measure the resistance between the SASM C2412-3, circuit VDB04 (WH/BU), harness side and the Data Link Connector (DLC) C251-6, circuit
VDB04 (WH/BU), harness side.
-
Measure the resistance between the SASM C2412-2, circuit VDB05 (WH), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.
-
Are the resistances less than 5 ohms?
Yes
CONNECT the negative battery cable. GO to H4.
No
REPAIR the circuit. CONNECT the negative battery cable. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
H4 CHECK FOR CORRECT SASM OPERATION
-
Disconnect the SASM connector.
-
Check for: