Ford Workshop Service and Repair Manuals

Remover, Oil Cooling Pipe

307 - 242 (17 - 049)

1. Disconnect the hose from the fluid reservoir.
   1. Detach the reservoir.
   2. Disconnect the hose.
   • Allow the fluid to drain into a suitable container.

2. Detach the hose from the bracket.

3. Raise and support the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.

4. Remove the radiator splash shield.
   • Remove the six screws.
   • Disconnect the air temperature sensor electrical connector (if equipped).

5. Using the special tool, disconnect the fluid cooler hose.
   1. Insert the special tool into the hose quick - release coupling.
   2. Move the special tool along the pipe to release the locking tangs.
   • Allow the fluid to drain into a suitable container.

6. 

   NOTE:Diesel vehicle shown, other variants similar.
   Remove the fluid cooler.

1. 

   NOTE:After installation bleed the power steering system. For additional information, refer to Section  211-00 Steering System - General Information.
   To install, reverse the removal procedure.