ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Water Pump Housing - 1.6L Zetec-E (Zetec)-1.8L Zetec-E (Zetec)-2.0L Zetec-E (Zetec) > < Water Pump - 1.6L Zetec-SE (Sigma)-1.4L

Focus 1999 (08.1998-12.2004)

Engine Cooling - Water Pump—1.6L Zetec-E (Zetec)/1.8L Zetec-E (Zetec)/2.0L Zetec-E (Zetec) Focus 1999 (08/1998-12/2004)
Removal and Installation

Removal

  1. Disconnect the battery ground cable. For additional information, refer to Section  414-01 Battery, Mounting and Cables.
  1. Drain the cooling system.
    For additional information, refer to Cooling System Draining, Filling and Bleeding in this section.

  1. Loosen the water pump pulley retaining bolts.
  1. Remove the accessory drive belt. For additional information, refer to Section  303-05 Accessory Drive.

  1. Remove the water pump pulley.

  1. Detach the water pump from the water pump housing.

  1. Rotate the water pump 180º within the water pump housing and remove it.
    • Discard the sealing ring

Installation
  1. NOTE:
    NOTE:Install a new water pump sealing ring.
    To install, reverse the removal procedure.
  1. Fill the cooling system.
    For additional information, refer to Cooling System Draining, Filling and Bleeding in this section.
  1. Initialize the door window motors. For additional information, refer to Section  501-11 Glass, Frames and Mechanisms.

Water Pump Housing - 1.6L Zetec-E (Zetec)-1.8L Zetec-E (Zetec)-2.0L Zetec-E (Zetec) > < Water Pump - 1.6L Zetec-SE (Sigma)-1.4L