| Removal and Installation Removal | | -
Remove the spring. For additional information, refer to: Spring - Wagon (204-02 Rear Suspension, Removal and Installation). | | | -
Fabricate a 20 mm wide by 184 mm long spacer. | | | -
CAUTION:The suspension must be set to the design height setting. Using a transmission jack and a wooden block, raise the suspension to the design height setting. | | | -
NOTE:The spacer must be positioned exactly as shown. Install the spacer. - Install the spacer between the rear lower arm and the rear axle crossmember making sure that the spacer is in a vertical plane.
| | | -
Detach the upper arm from the wheel knuckle. | | | -
NOTE:Make a note of the position of the upper arm to aid installation. Remove the upper arm. | Installation | | -
Install the upper arm to the rear axle crossmember. | | | -
Attach the upper arm to the wheel knuckle. | | | -
Lower the suspension from the design height setting. | | | -
Install the spring. For additional information, refer to: Spring - Wagon (204-02 Rear Suspension, Removal and Installation). | | |
