| In-vehicle Repair Special Tool(s) | | Remover, Crankshaft Seal 303-293 | | | Aligner/Installer, Crankshaft Front Seal 303-318 | | | -
Remove the timing belt.
For additional information, refer to: Timing Belt - Vehicles Built Up To: 04/2005 (303-01B Engine - 1.6L Duratec-16V Ti-VCT (Sigma), In-vehicle Repair) /
Zahnriemen - gebaut ab 04/2005 (303-01B, In-vehicle Repair).
| | | -
CAUTION:Counterhold the camshafts at the hexagon using an open-ended spanner to prevent the camshafts from rotating. Remove the VCT elements. | 3. Remove the components in the order indicated in the following illustration(s) and table(s). 4. To install, reverse the removal procedure. NOTE:Do not yet tighten the VCT elements. Ensure that the VCT elements can still be moved freely on the camshafts. Removal Details Item 1 : Camshaft seals | | -
Remove the camshaft seals using the special tool. | Installation Details Item 1 : Camshaft seals | | -
Install the camshaft seals using the special tool. | |
/Description and Operation/Diagnosis and Testing/General Procedures/In-vehicle Repair//img/21143.jpg)
/Description and Operation/Diagnosis and Testing/General Procedures/In-vehicle Repair//img/21148A.jpg)
/Description and Operation/Diagnosis and Testing/General Procedures/In-vehicle Repair//img/E48564.jpg)
/Description and Operation/Diagnosis and Testing/General Procedures/In-vehicle Repair//img/E48568.jpg)
/Description and Operation/Diagnosis and Testing/General Procedures/In-vehicle Repair//img/E48569.jpg)
