| Removal and Installation | | -
Disconnect the battery ground cable.
For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
| | | -
Remove the air cleaner.
For additional information, refer to: Air Cleaner - 1.6L Duratec-16V Ti-VCT (Sigma) (303-12A Intake Air Distribution and Filtering, Removal and Installation).
| | | -
Remove the throttle body.
For additional information, refer to: Throttle Body (303-04B Fuel Charging and Controls - 1.6L Duratec-16V Ti-VCT (Sigma), Removal and Installation).
| | | -
Remove the starter motor retaining bolt. | | | -
Raise and support the vehicle.
For additional information, refer to: Lifting (100-02, Description and Operation).
| 6. Remove the components in the order indicated in the following illustration(s) and table(s). 1 - Battery to starter motor solenoid cable electrical connector retaining nut 2 - Ignition switch to starter motor solenoid cable electrical connector retaining nut 4 - Starter motor upper retaining bolt 7. To install, reverse the removal procedure. | | -
Initialize the door window motors.
For additional information, refer to: Door Window Motor Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).
| Removal Details Item 3 : Starter motor electrical connector | | -
Detach the starter motor electrical connector. | Item 5 : Starter motor lower retaining bolt | | -
Support the starter motor. | |
