| Removal and Installation | | -
NOTE:Make sure that the windshield wiper motor is in the park position. Disconnect the battery ground cable.
For additional information, refer to: Battery Disconnect (414-01 Battery, Mounting and Cables, General Procedures).
| | | -
Remove the engine upper cover. | | | -
Detach the brake fluid reservoir from the bulkhead extension panel. | | | -
Remove the windshield wiper arms. | | | -
Remove the cowl panel. - Detach the cowl panel from the retaining clips.
- Remove the cowl panel by detaching it from the windshield glass lower weatherstrip.
| | | -
Remove the bulkhead extension panel. - Remove the bulkhead extension panel retaining screws.
- Detach the bulkhead extension panel from the retaining clips.
| 7. Remove the components in the order indicated in the following illustration(s) and table(s). 4 - CMP sensor electrical connector 5 - CMP sensor retaining bolt 8. To install, reverse the removal procedure. | | -
Vehicles with global closing, initialize the door window motors.
For additional information, refer to: Door Window Motor Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).
| Removal Details Item 1 : Fuel filter fuel supply and fuel filter fuel return lines support bracket | | -
Detach the fuel filter fuel supply and fuel filter fuel return lines support bracket from the timing belt upper cover. | Item 2 : Engine wiring harness retaining clip | | -
Detach the engine wiring harness retaining clip from the timing belt upper cover. | Item 3 : Timing belt upper cover | | -
Remove the timing belt upper cover. - Remove the timing belt upper cover retaining bolts.
- Slide the timing belt upper cover upwards to disengage the retaining tang.
| Installation Details Item 6 : CMP sensor CAUTION:The CMP sensor tip must rest on the back of one of the three webs of the camshaft pulley. Incorrect installation may result in the CMP sensor being damaged. NOTE:Only turn the engine in the normal direction of rotation. | | -
Turn the engine until the back of one of the three webs of the camshaft pulley is in line with the CMP sensor hole in the timing belt cover back plate. | | | -
Install the CMP sensor until the tip of the sensor touches the back of the camshaft pulley. | |
