ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Turbine Shaft Speed (TSS) Sensor > < Transmission Fluid Pan, Gasket and Filter

Focus 2004.75 (07.2004-)

Automatic Transmission/Transaxle - Vehicles With: 4-Speed Automatic Transmission (4F27E) - Main Controls Focus 2004.75 (07/2004-)
In-vehicle Repair

Removal

  1. Remove the fluid pan.
    For additional information, refer to Fluid Pan in this section.

  1. Disconnect the transmission fluid temperature (TFT) sensor electrical connector.

  1. Remove the fluid filter.

  1. NOTE:
    NOTE:It is necessary to note the location of the main control wire harness connectors so they can be connected in the same positions. Connector color letters are cast into the solenoid body.
    Remove the ground wire bolt. Disconnect the electrical connectors and remove the main control wiring harness.
    1. Solenoid SSC; Color N (Neutral/White).
    1. Solenoid SSE; Color G (Green).
    1. Solenoid SSD; Color L (Blue).
    1. Solenoid EPC; Color B (Black).
    1. Solenoid SSA; Color N (Neutral).
    1. Solenoid SSB; Color B (Black).

  1. NOTE:
    NOTE:Note the locations of the two long bolts.
    Remove the main control valve body and accumulators.

  1. NOTE:
    NOTE:Each accumulator is equipped with two springs. All four springs are different sizes.
    NOTE:
    NOTE:Note the size and location of the accumulator springs to aid assembly.
    Remove the accumulator pistons and springs.

Installation
  1. NOTE:
    NOTE:The thin longer springs are for the neutral and drive accumulator.
    Install the accumulator pistons and springs.
    1. Accumulator 1 and 2.
    1. Accumulator N and D.

  1. CAUTION:
    CAUTION:Make sure that the manual valve is in the manual control valve shift lever.
    NOTE:
    NOTE:Do not fully tighten the main control valve bolts at this stage.
    Install the main control valve body.

  1. Tighten the main control valve body retaining bolts.
    • Tighten the bolts in the sequence shown.

  1. NOTE:
    NOTE:It is necessary to connect the electrical connectors in the same positions as noted in disassembly. Connector color letters are cast into the solenoid body.
    Install the main control valve wiring harness, connect the electrical connectors and install the ground wire bolt.
    1. Solenoid SSC; Color N (Neutral/White).
    1. Solenoid SSE; Color G (Green).
    1. Solenoid SSD; Color L (Blue).
    1. Solenoid EPC; Color B (Black).
    1. Solenoid SSA; Color N (Neutral).
    1. Solenoid SSB; Color B (Black).

  1. Install the fluid filter.

  1. Connect the TFT sensor electrical connector.
  1. Install the fluid pan.
    For additional information, refer to Fluid Pan in this section.

Turbine Shaft Speed (TSS) Sensor > < Transmission Fluid Pan, Gasket and Filter