ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Halfshaft Seal LH > < Transmission Fluid Pan, Gasket and Filter

Focus 2004.75 (07.2004-)

Automatic Transmission/Transaxle - Vehicles With: Automatic Transmission (CFT23) - Mechatronic Assembly Focus 2004.75 (07/2004-)
In-vehicle Repair

Removal

CAUTION:
CAUTION:Do not touch the electrical connector pins. Electrostatic charge may occur and will cause damage to the mechatronic assembly.
  1. Drain the transmission.
    For additional information, refer to: Transmission Fluid Drain and Refill (307-01B Automatic Transmission/Transaxle - Vehicles With: Automatic Transmission (CFT23), General Procedures).

  1. Disconnect the transmission central electrical connector.

  1. Remove the transmission main electrical connector retaining bolt.

  1. Remove the transmission main electrical connector.
    1. Rotate the transmission main electrical connector counterclockwise.
    1. Pull the transmission main electrical connector upwards.
  1. Remove the fluid pan and the fluid filter.
    For additional information, refer to: Transmission Fluid Pan, Gasket and Filter (307-01B Automatic Transmission/Transaxle - Vehicles With: Automatic Transmission (CFT23), In-vehicle Repair).

  1. Disconnect the output shaft speed (OSS) sensor and the mechatronic assembly electrical connectors.

  1. NOTE:
    NOTE:Make a note of the position of the mechatronic assembly retaining bolts to aid installation.
    Remove the mechatronic assembly.

  1. NOTE:
    NOTE:Make a note of the position of the mechatronic assembly oil feed tubes to aid installation.
    Remove the mechatronic assembly oil feed tubes.

Installation

CAUTION:
CAUTION:Do not touch the electrical connector pins. Electrostatic charge may occur and will cause damage to the mechatronic assembly.
  1. NOTE:
    NOTE:Clean the mechatronic assembly oil feed tube seals and check them for damage. Install new mechatronic assembly oil feed tube seals as necessary.
    NOTE:
    NOTE:Make sure that the mechatronic assembly oil feed tubes are installed in their original positions.
    Install the mechatronic assembly oil feed tubes.

  1. NOTE:
    NOTE:Make sure that the mechatronic assembly retaining bolts are installed in their original positions.
    Install the mechatronic assembly.
    • Tighten the mechatronic assembly retaining bolts in the sequence shown in 2 stages.
    • Stage 1: 5 Nm.
    • Stage 2: 10 Nm.

  1. Connect the output shaft speed (OSS) sensor and the mechatronic assembly electrical connectors.
  1. Install the fluid pan and the fluid filter.
    For additional information, refer to: Transmission Fluid Pan, Gasket and Filter (307-01B Automatic Transmission/Transaxle - Vehicles With: Automatic Transmission (CFT23), In-vehicle Repair).

  1. Install the transmission main electrical connector.
    1. Push the transmission main electrical connector downwards.
    1. Rotate the transmission main electrical connector clockwise.

  1. Install the transmission main electrical connector retaining bolt.

  1. Connect the transmission central electrical connector.
  1. Fill the transmission with transmission fluid.
    For additional information, refer to: Transmission Fluid Drain and Refill (307-01B Automatic Transmission/Transaxle - Vehicles With: Automatic Transmission (CFT23), General Procedures).

Halfshaft Seal LH > < Transmission Fluid Pan, Gasket and Filter