ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Rear Center Safety Belt Retractor - 2.0L Duratec-RS (Zetec) > < Front Safety Belt Retractor - 2.0L Duratec-RS (Zetec)

Focus RS 2003 (09.2002-)

Safety Belt System - Safety Belt Shoulder Height Adjuster—2.0L Duratec-RS (Zetec) Focus RS 2003 (09/2002-)
Removal and Installation

Removal
  1. Detach the safety belt lower anchor.
    1. Remove the Torx bolt from the anchor rail.
    1. Slide the safety belt off the anchor rail.

  1. NOTE:
    NOTE:Certain production trim panels have a retaining clip on the front edge.
    Detach the B-pillar upper trim panel.
    1. Detach the retaining clips.
    1. Remove the lower anchor bolt and spacer from the safety belt webbing.
    1. Feed the safety belt webbing through the B-pillar upper trim panel.

  1. Detach the upper safety belt anchor.

  1. Remove the height adjuster.

Installation
  1. CAUTION:
    CAUTION:Make sure the spacer is correctly located between the floor covering and inner sill.
    CAUTION:
    CAUTION:Make sure the pin on the B-pillar trim is located correctly into the height adjuster.
    CAUTION:
    CAUTION:Make sure that the rear end of the anchor rail is correctly located before tightening the Torx bolt.
    To install, reverse the removal procedure.

Rear Center Safety Belt Retractor - 2.0L Duratec-RS (Zetec) > < Front Safety Belt Retractor - 2.0L Duratec-RS (Zetec)