General Procedures Special Tool(s) | Aligner, Gearshift Lever 308-235 (16-083) | | -
Remove the gearshift lever knob, turn it counterclockwise. | | -
Detach the trim panel from the floor console. | | -
Remove the floor console trim panel. - Disconnect the electrical connector.
| | -
NOTE:Make sure the gearshift mechanism is in the neutral position. Detach the gearshift cable and the selector cable from the bracket. - Pull the locking mechanism backwards, and turn it counterclockwise.
| | -
Using the special tool, lock the gearshift lever. - Attach the selector cable (colored blue) to the bracket.
- Attach the gearshift cable (colored black) to the bracket.
| | -
Check the gearshift mechanism adjustment. - The gearshift lever must rest in the shift passage between third and fourth gear when in the neutral position.
- Shift into all gears and check for correct gear selection.
| | -
Install the floor console trim panel. - Connect the electrical connector.
| | -
Attach the trim panel to the floor console. | | -
Install the gearshift lever knob, turn it clockwise. | | |