ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Crankshaft Front Seal > < Camshaft

Ikon 1999 (01.2000-)

Engine - 1.8L Endura-DE (Kent) Diesel - Camshaft Seal Ikon 1999 (01/2000-)
In-vehicle Repair

Special Tool(s)

15-030 A Universal flange holding wrench

15-030 A Universal flange holding wrench

Installer, camshaft oil seal

21-110

Remover, camshaft oil seal

21-143
General Equipment
Two-legged puller
Materials
Name
Specification
Engine Oil
ACEA A3/B3 

Removal

  1. General note.
    • This operation was carried out on an engine with a mechanical timing belt tensioner.
  1. Remove camshaft timing belt as described in Operation No. 21 304 0.
  1. CAUTION:
    CAUTION:Support the engine with a trolley jack.
    Detach the engine support bar.

  1. Slacken the flange bolt of the camshaft timing pulley.

  1. Remove the camshaft timing pulley.

  1. Remove the flange bolt of the camshaft timing pulley.

  1. Pull off the flange of the camshaft timing pulley.
    • Take out the Woodruff key.

  1. Remove the camshaft oil seal.

  1. NOTE:
    NOTE:Coat the running surface and the sealing lip of the oil seal with engine oil. The text on the oil seal faces outwards during installation.
    Draw in the camshaft seal using the installer and an M8 bolt.

  1. Fit the flange of the camshaft timing pulley.
    • Insert the Woodruff key.
    • Draw on the flange with the bolt.

  1. Fit the camshaft timing pulley.

  1. Tighten the flange bolt of the camshaft timing pulley.
  1. Attach the engine support bar.
  1. Fit a new camshaft timing belt, as described in Operation No. 21 304 0.

Crankshaft Front Seal > < Camshaft