ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Coolant Expansion Tank > < Radiator

Ikon 1999 (01.2000-)

Engine Cooling - Cooling Fan Motor Ikon 1999 (01/2000-)
Removal and Installation

Removal

  1. Disconnect the battery ground cable. For additional information, refer to Section  414-01 Battery, Mounting and Cables.

  1. Remove the cooling fan shroud right-hand retaining nut.

  1. Remove the cooling fan shroud left-hand retaining nut.
  1. Remove the engine undershield (if equipped). For additional information, refer to Section  502-00 Uni-Body, Subframe and Mounting System.

  1. Disconnect and detach the cooling fan motor resistor electrical connector.

  1. Disconnect and detach the cooling fan motor relay electrical connector.

  1. Disconnect the cooling fan motor electrical connector.

  1. Remove the cooling fan motor and shroud.
    • Raise the cooling fan motor and shroud upwards out of the radiator lower locating brackets.

  1. Detach the cooling fan motor wiring harness.

  1. Remove the cooling fan motor.

Installation

  1. To install, reverse the removal procedure.

Coolant Expansion Tank > < Radiator