ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Air Inlet Blend Door Actuator > < Climate Control Assembly

Ikon 1999 (01.2000-)

Control Components - Blower Motor Switch Ikon 1999 (01/2000-)
Removal and Installation

Removal

  1. Standard preparatory measures
    • Ask for the radio keycode.
    • Make a note of the preset radio stations.
    • Place protective covers over the wings.
  1. CAUTION:
    CAUTION:Disconnect the battery ground lead.
    Remove the radio. For additional information, refer to Section  415-01 Audio Unit.

  1. Remove the bezel.
    1. Remove the bolts.
    1. Unclip the clips.
    • Pull the bezel forwards.
    • Disconnect the plug.

  1. Unclip the air distribution shaft.

  1. Remove the fan motor operating switch.

Installation

  1. Refit the components in the reverse order.
  1. Install the radio. For additional information, refer to Section  415-01 Audio Unit.
  1. Standard finishing operations.
    • Connect the battery ground lead.
    • Remove the protective covers.
    • Enter the radio keycode.
    • Reprogramme the preset radio stations.
    • Reset the clock.
  1. Check the operation of the heater.

Air Inlet Blend Door Actuator > < Climate Control Assembly