ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Blower Motor Switch > < Control Components

Ikon 1999 (01.2000-)

Control Components - Climate Control Assembly Ikon 1999 (01/2000-)
Removal and Installation

Removal

  1. Standard preparatory measures
    • Make a note of the radio keycode.
    • Make a note of the preset radio stations.
  1. CAUTION:
    CAUTION:Disconnect the battery negative lead.
    Remove the radio. For additional information, refer to Section  415-01 Audio Unit.

  1. NOTE:
    NOTE:The control unit for the heating/air conditioning system, all operating knobs and the air distribution operating switch make up one assembly.
    Remove the bezel.
    1. Remove the screws.
    1. Unclip the clips.
    • Pull the bezel forwards.
    • Disconnect the plug.

  1. Unclip the air distribution shaft.

  1. Remove the heater/air conditioning module and the fan operating switch.

Installation

  1. Refit the components in the reverse order.
  1. Install the radio. For additional information, refer to Section  415-01 Audio Unit.
  1. Connect the battery ground lead.
    • Enter the radio keycode.
    • Reprogramme the preset radio stations.
    • Reset the clock.
    • Carry out a road test to enable the PCM to collect data.
  1. Check that the heater/air conditioning operates properly.

Blower Motor Switch > < Control Components