Removal and Installation Electric hand drill Blind rivet gun-hand Removal | -
CAUTION:Do not touch the adhesive surface as rebonding will be impaired. Detach the watershield. | | -
Connect the window control switch electrical connector. | | -
Remove the window glass retaining screws. - Align the retaining screws with the access hole.
| | -
Detach the window glass from the window regulator. | | -
CAUTION:Make sure the window glass is adequately supported at the top of the opening. Using suitable hooks, raise and secure the window glass. | | -
Disconnect the window regulator motor electrical connector. | | -
Using a suitable electric hand drill, remove the rivets. | | -
Remove the window regulator and motor. | Installation | -
NOTE:Do not fully tighten the retaining nuts at this stage. Install the window regulator and motor. | | -
Using a suitable blind rivet gun-hand, install new rivets. | | -
Tighten the window regulator and motor retaining nuts. | | -
Connect the window regulator motor electrical connector. | | -
CAUTION:Make sure the window glass is adequately supported at the top of the opening. Remove the hooks. | | -
Align the window regulator clamp with the access hole. | | -
Attach the window glass to the window regulator clamp. | | -
Disconnect the window control switch electrical connector. | | |