ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Front Door Glass Top Run > < Front Door Window Regulator and Motor
Glass, Frames and Mechanisms - Rear Door Window Regulator and Motor Ikon 1999 (01/2000-)
Removal and Installation

Electric hand drill
Blind rivet gun-hand

Removal

  1. Remove the door trim panel. For additional information, refer to Section  501-05 Interior Trim and Ornamentation.

  1. CAUTION:
    CAUTION:Do not touch the adhesive surface as re-bonding will be impaired.
    Detach the watershield.
  1. Connect the window control switch electrical connector.

  1. Remove the window glass retaining screws.
    • Align the retaining screws with the access hole.
  1. Detach the window glass from the regulator.

  1. CAUTION:
    CAUTION:Make sure the window glass is adequately supported at the top of the opening.
    Using suitable hooks, raise and secure the window glass.

  1. Disconnect the regulator motor electrical connector.

  1. Using a suitable electric hand drill, remove the rivets.

  1. Remove the regulator and motor.

Installation

  1. NOTE:
    NOTE:Do not fully tighten the retaining nuts at this stage.
    Install the regulator and motor.

  1. Using a suitable blind rivet gun-hand, install new rivets.

  1. Tighten the window regulator and motor retaining nuts.

  1. Connect the regulator motor electrical connector.

  1. CAUTION:
    CAUTION:Make sure the window glass is adequately supported at the top of the opening.
    Remove the hooks.
  1. Align the regulator clamp with the access hole.

  1. Attach the window glass to the regulator clamp.
  1. Adjust the window glass.
    For additional information, refer to Door Window Glass Adjustment in this section.
  1. Disconnect the window control switch electrical connector.
  1. Attach the watershield.
  1. Install the door trim panel. For additional information, refer to Section  501-05 Interior Trim and Ornamentation.

Front Door Glass Top Run > < Front Door Window Regulator and Motor