Ford Workshop Service and Repair Manuals

Remover, Transfer Case Bearing Cup

308-125 (T87P-7120-D)

Installer, Needle Bearing

307-294 (T94P-77000-K)

Handle, Universal

205-153 (T80T-4000-W)

Slide Hammer

100-001 (T50T-100-A)

Input Shaft Bearing Remover

308-201 (T91T-7127-A)

1. 

   CAUTION:Clamp the sprocket in a soft-jawed vise.
   Using the special tools, remove the No. 16 reverse/overdrive ring gear bearing, as necessary.

2. Using the special tools, remove the No. 17 stator support bearing, as necessary.

1. Position the No. 16 reverse/overdrive ring gear bearing on the special tools.
   • Position the bearing with the part number facing toward the handle of the special tool.

2. 

   NOTE:The identification stamping of the bearing goes to the outboard side of the reverse/overdrive ring gear.
   Using the special tools, install the No. 16 reverse/overdrive ring gear bearing.

3. Position the No. 17 stator support bearing on the special tools.
   • Position the bearing with the part number facing toward the handle of the special tool.

4. 

   NOTE:The identification stamping of the bearing goes to the outboard side of the reverse/overdrive ring gear.
   Using the special tools, install the No. 17 stator support bearing into the stator support sprocket.