ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Valve Seals > < Crankshaft Front Seal

Mondeo 1997 (08.1996-09.2000)

Engine - 1.8L Diesel - Auxiliary Shaft Seal Mondeo 1997 (08/1996-09/2000)
In-vehicle Repair

Materials
Name
Specification
Engine oil 5W-30
WSS-M2C912-A1 

Removal

  1. Remove cambelt.
    For additional information, refer to Timing belt in this section.
  1. Raise the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.

  1. Detach crankshaft pulley/vibration damper from flange.

  1. Detach rear cover on auxiliary shaft timing belt and timing pulley.
    1. Rear timing belt cover on cylinder block
      NOTE:
      NOTE:Hold auxiliary shaft timing pulley using old timing belt.
    1. Auxiliary shaft timing pulley

  1. Detach auxiliary shaft oil seal carrier.

Installation
  1. Fit auxiliary shaft oil seal carrier.
    • Fit new auxiliary shaft oil seal carrier with integral oil seal and installer onto auxiliary shaft spigot.
    1. Tighten bolts.
    1. Remove installer after fitting and check seal seat.

  1. Fit auxiliary shaft timing pulley and rear timing belt cover.
      NOTE:
      NOTE:Hold using old timing belt.
    1. Auxiliary shaft timing pulley
    1. Rear timing belt cover on cylinder block

  1. Fit crankshaft pulley/vibration damper on flange.
  1. Lower the vehicle.
  1. Install cambelt.
    For additional information, refer to Timing belt in this section.

Valve Seals > < Crankshaft Front Seal