ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Fuel Charging and Controls > < Fuel Injection Supply Manifold

Mondeo 1997 (08.1996-09.2000)

Fuel Charging and Controls - 2.5L - Fuel Pressure Regulator Mondeo 1997 (08/1996-09/2000)
Removal and Installation

Removal

WARNING:
WARNING:Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable mixtures are always present and can ignite. Failure to follow these instructions can result in personal injury.
  1. Disconnect the battery ground cable. For additional information, refer to Section  414-01 Battery, Mounting and Cables.
  1. Depressurize the fuel system. For additional information, refer to Section  310-00A Fuel System - General Information / 310-00B Fuel System - General Information.
  1. Remove the upper intake manifold. For additional information, refer to Section  303-01A Engine / 303-01B Engine / 303-01C Engine / 303-01D Engine.

  1. Disconnect the vacuum pipe.

  1. Remove the fuel pressure regulator.
    • Discard the seal and the O-rings.

Installation

WARNING:
WARNING:Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable mixtures are always present and can ignite. Failure to follow these instructions can result in personal injury.
  1. Make sure that the sealing surfaces of the fuel pressure regulator and the fuel rail are clean.

  1. CAUTION:
    CAUTION:Install the fuel pressure regulator outlet tube into the fuel rail carefully to avoid damaging the seal.
    To install, reverse the removal procedure.

Fuel Charging and Controls > < Fuel Injection Supply Manifold