| Removal and Installation Removal All Vehicles | | -
Remove the door speaker. - Disconnect the speaker electrical connector.
| | | -
CAUTION:Do not touch the adhesive surface as re-bonding will be impaired. Detach the watershield. - Using a plastic knife (disposable cutlery), cut through the Butyl strip to enable the watershield to be peeled back.
| Vehicles with power windows | | -
Connect the power window operating switch electrical connector. | Vehicles with manual windows | | -
Install the window regulator handle. | All Vehicles | | -
NOTE:Align the window retaining bolts with the access holes. Remove the window retaining bolts. | Vehicles with power windows | | -
Disconnect the battery ground cable. | Vehicles with manual windows | | -
Remove the window regulator handle. | All Vehicles | | -
Raise and support the glass in the fully closed position (power window shown). | | | -
Detach the window regulator motor and window regulator (power window shown). - Remove the window regulator bolts and allow the window regulator to rest in the bottom of the door.
- Remove the window regulator motor (three bolts), or manual window regulator (two bolts), and allow the window regulator to rest in the bottom of the door.
| Vehicles with power windows | | -
Disconnect the window regulator motor electrical connector. | All Vehicles | | -
Remove the window regulator (power window shown). | Vehicles with power windows | | -
Remove the motor mounting bushes. | Installation | | -
To install, reverse the removal procedure. | |
