ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Crankshaft Pulley > < Valve Cover LH

Mondeo 2001 (10.2000-02.2007)

Engine - 2.5L Duratec-VE (VE6) - Valve Cover RH Mondeo 2001 (10/2000-02/2007)
In-vehicle Repair

Materials
Name
Specification
Silicone Sealant
WSE-M4G323-A4 

Removal

  1. Remove the upper intake manifold.
    For additional information, refer to: Upper Intake Manifold (303-01C Engine - 2.5L Duratec-VE (VE6), In-vehicle Repair).

  1. Disconnect the right-hand spark plug electrical connectors.
    • Detach the bracket.

  1. Remove the electronic ignition (EI) coil.
    • Disconnect the electrical connectors.

  1. Detach the front wiring harness bracket from the right-hand valve cover (if equipped).

  1. Detach the rear wiring harness bracket from the right-hand valve cover (if equipped).

  1. Detach the wiring rail from the right-hand valve cover.

  1. Remove the right-hand valve cover.
    • Remove the right-hand valve cover retaining bolts in the sequence shown.
    • Discard the gasket.

Installation
  1. Clean the mating faces of the cylinder head and the right-hand valve cover with a clean lint free cloth.
    • Apply sealant to the mating faces of the cylinder head.

  1. NOTE:
    NOTE:Install a new gasket.
    Install the right-hand valve cover.
    • Tighten the valve cover retaining bolts in the sequence shown.

  1. Attach the wiring rail to the right-hand valve cover.

  1. Attach the rear wiring harness bracket to the right-hand valve cover (if equipped).

  1. Attach the front wiring harness bracket to the right-hand valve cover (if equipped).

  1. Install the EI coil.
    • Connect the electrical connectors.

  1. Connect the right-hand spark plug electrical connectors.
    • Attach the bracket.
  1. Install the upper intake manifold.
    For additional information, refer to: Upper Intake Manifold (303-01C Engine - 2.5L Duratec-VE (VE6), In-vehicle Repair).

Crankshaft Pulley > < Valve Cover LH