ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Evaporative Emission Canister Purge Valve - 3.0L Duratec-SE (VE6)-3.0L Duratec-ST (VE6) > < Evaporative Emission Canister - Wagon

Mondeo 2001 (10.2000-02.2007)

Evaporative Emissions - Evaporative Emission Canister Purge Valve—1.8L Duratec-SCi (MI4) Mondeo 2001 (10/2000-02/2007)
Removal and Installation

WARNING:
WARNING:Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable mixtures are always present and can ignite. Failure to follow these instructions may result in personal injury.
  1. Remove the engine upper cover.

2. Remove the components in the order indicated in the following illustration(s) and table(s).

 
Item
Part Number
Description
1
-
Evaporative emission canister vacuum pipe quick release coupling
See Removal Detail
2
-
Evaporative emission canister purge valve electrical connector
3
-
Evaporative emission canister purge valve

3. To install, reverse the removal procedure.

Removal Details

Item 1 : Evaporative emission canister vacuum pipe quick release coupling

  1. Disconnect the evaporative emission canister vacuum pipe quick release coupling. For additional information, refer to Section  310-00 Fuel System - General Information.
  1. Detach the evaporative emission canister vacuum pipe from the cylinder head retaining clip.

Evaporative Emission Canister Purge Valve - 3.0L Duratec-SE (VE6)-3.0L Duratec-ST (VE6) > < Evaporative Emission Canister - Wagon