ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Evaporative Emission Canister Purge Valve - 1.8L Duratec-SCi (MI4) > < Evaporative Emission Canister - 4-Door-5-Door

Mondeo 2001 (10.2000-02.2007)

Evaporative Emissions - Evaporative Emission Canister—Wagon Mondeo 2001 (10/2000-02/2007)
Removal and Installation

Removal

WARNING:
WARNING:Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.
  1. Raise and support the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.

  1. Disconnect the fuel tank vent pipe and evaporative emission purge valve pipe from the evaporative emission canister.

  1. Remove the evaporative emission canister housing retaining bolts.

  1. Detach the water separator box cover from the evaporative emission canister water separator box.

  1. Remove the evaporative emission canister from the evaporative emission canister housing.
    1. Push the evaporative emission canister forward.
    1. Lift the evaporative emission canister up and remove.

Installation

WARNING:
WARNING:Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.
  1. To install, reverse the removal procedure.

Evaporative Emission Canister Purge Valve - 1.8L Duratec-SCi (MI4) > < Evaporative Emission Canister - 4-Door-5-Door