ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Assembly > < Differential

Mondeo 2007.5 (02.2007-)

Manual Transmission/Transaxle - Vehicles With: 6-Speed Manual Transmission (MMT6) - 5th-6th and Reverse Gear Output Shaft Mondeo 2007.5 (02/2007-)
Disassembly and Assembly of Subassemblies

Special Tool(s)
204-050
Installer, Front Wheel Hub Bearing Cup/Seal

205-071-01
Adapter for 205-071 (Thrust Pad)

205-295
Remover, Bearing (Main Tool)

308-046
Installer, Transmission Extension Housing Bushing/Seal

308-196
Collet for 205-295

308-197
Collet for 205-295

308-604
Installer, Output Drive Flange Seal
Materials
Name
Specification
Transmission Fluid
WSD-M2C200-C
General Equipment
Hot air gun

Disassembly

CAUTION:
CAUTION:Use protective covers.
  1. Clamp the output shaft in a vise.

  1. Special Tool(s): 205-071-01, 205-295, 308-197

  1. NOTE:
    NOTE:Left-hand thread
    General Equipment: Hot air gun

  1. NOTE:
    NOTE:Use a suitable washer as a thrust element.
    Special Tool(s): 205-295, 308-196

  1. CAUTION:
    CAUTION:Note the position of each component before removal.
    1. Sliding collar
    1. Blocker bar
    1. Synchroniser hub

  1. CAUTION:
    CAUTION:Note the position of each component before removal.
    1. Sliding collar
    1. Blocker bar
    1. Synchroniser hub
    1. Snap ring

Assembly

CAUTION:
CAUTION:Use protective covers.
  1. Clamp the output shaft in a vise.

  1. CAUTION:
    CAUTION:Make sure that no oil ring is installed.
  1. Coat all running surfaces with clean transmission fluid before assembly.
    Material: Transmission Fluid

  1. NOTE:
    NOTE:Make sure that the installation marks are aligned.
    1. Synchroniser hub
    1. Blocker bar
    1. Sliding collar
    1. Snap ring

  1. Special Tool(s): 308-604

  1.  
    1. NOTE:
      NOTE:Make sure that a new component is installed.
    1. The collar on the retaining ring must face upward.

  1. NOTE:
    NOTE:Make sure that the installation marks are aligned.
    1. Synchroniser hub
    1. Blocker bar
    1. Sliding collar

  1. Special Tool(s): 308-604

  1. NOTE:
    NOTE:Make sure that a new component is installed.

  1. NOTE:
    NOTE:Make sure that a new component is installed.
    NOTE:
    NOTE:Do not oil taper roller bearings.
    Special Tool(s): 308-046

  1. CAUTION:
    CAUTION:Make sure that a new bolt is installed.
    NOTE:
    NOTE:Make sure that the component is clean and free of foreign material.
    NOTE:
    NOTE:Left-hand thread.

  1. NOTE:
    NOTE:Make sure that a new component is installed.
    NOTE:
    NOTE:Do not oil taper roller bearings.
    Special Tool(s): 204-050

Assembly > < Differential