Mustang V6-4.0L (2008)
10. Using the special tool, prevent the crankshaft from turning, tighten the jackshaft sprocket bolt in 2 stages.
^
Stage 1: Tighten to 45 Nm (33 lb-ft).
^
Stage 2: Tighten an additional 90 degrees.
11. Loosely install the camshaft sprocket bolt.
12. Install the engine front cover.
13. NOTE: The LH and RH camshafts must be retimed when either camshaft is disturbed.
NOTE: The LH hydraulic chain tensioner will be installed during camshaft timing.
Retime the LH and RH camshafts.
14. Install the camshaft roller followers.
15. Install the intake manifold.
16. Connect the battery ground cable. For additional information, refer to Battery.
17. Fill and bleed the engine cooling system.
