Mustang V8-4.6L VIN H (2005)
electrical connector glued to the ECU. It cannot and should not be disconnected or altered.
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
All seats
1. Position the seat to access all the seat track-to-floor pan bolts.
2. Depower the supplemental restraint system (SRS).
3. Remove the passenger seat.
4. Remove the seat backrest.
5. Release the seat trim cover and foam pad.
-
Release the 5 J-clips and one pin-type retainer in the RH front corner.
6. CAUTION: Use care when separating the seat upholstery from the hook and loop strip, or the hook and loop strip can be torn from the
seat cushion foam pad.
Separate the trim cover from the foam pad.
-
Release the hook and loop fasteners and remove the hog rings.
7. NOTE: Production pressure sensor shown, service kit pressure sensor similar.
Bend to release the retaining tab and remove the pressure sensor from the bracket.
