Mustang V8-4.6L VIN H (2005)
All seats
12. NOTE: Production electronic control unit (ECU) shown, service kit ECU similar.
Remove the rivets and separate the ECU from the seat cushion pan bracket.
13. NOTE: Note position of hose routing for installation.
Remove the OCS from the seat cushion pan.
-
Feed the hose, pressure sensor, wire harness, electrical connector and ECU through the opening in the seat cushion pan assembly.
Installation
All seats
1. WARNING: Do not separate components.
CAUTION:
-
Inspect the occupant classification sensor assembly, seat cushion frame and support assembly for any foreign objects, before installing
the occupant classification sensor assembly to the seat cushion frame. If any foreign objects are found, remove them. Failure to do so
may result in personal injury, in the event of an air bag deployment.
-
Failure to route the seat occupant sensor components through the correct seat cushion support opening can cause component failure.
-
While positioning the seat cushion pan and occupant classification sensor assembly, be careful not to damage any of the components.
Failure to do so can result in component failure.
NOTE: If the original equipment occupant classification sensor (OCS) is not being installed, install a service kit OCS using all parts in the kit.
