Removal and Installation Special Tool(s) | Oil Seal Installer 49 S011 103 | | -
Disconnect the negative battery cable. For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures). | | -
Remove the dual-mass flywheel. For additional information, refer to: Clutch Disc and Pressure Plate (308-01 Clutch, Removal and Installation). | 3. Remove the components in the order indicated in the following illustration(s) and table(s). 4. To install, reverse the removal procedure. | -
Inspect the engine oil level. For additional information, refer to: Engine Oil Draining and Filling (303-01 Engine - 2.5L Duratorq-TDCi (WL) Diesel/3.0L Duratorq-TDCi (WL) Diesel, General Procedures). | Removal Details Item 1 : Rear oil seal | -
Cut the oil seal lip by using a razor knife. | | -
Remove the oil seal by using a screwdriver protected with a rag. | Installation Details Item 1 : Rear oil seal | -
Apply soapy water along the perimeter of the new oil seal. | | -
Tap the oil seal in evenly using the SST and a hammer. | |