| Removal and Installation Removal | | -
Remove the wheel and tire. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation). | | | -
Remove the tire from the wheel, release the tire bead from the rim 180 degrees from the valve. | Installation | | -
NOTE:Make sure that the seal is correctly located. Install a new washer and seal, making sure the valve remains pressed fully onto its seat. | | | -
WARNING:Make sure that any corrosion or dirt is removed from the mating faces. WARNING:Make sure that a new nut is installed. CAUTION:Use lint free cloth. -
NOTE:Only tighten the nut finger tight at this stage. Install the tire low pressure sensor and support the sensor body in position. -
Support the back of the valve stem in order to prevent rotation and damage to the tire low pressure sensor body. -
CAUTION:Only use moderate force when installing the sensor. Gently push the nut towards the center of the wheel. Tighten the nut. Torque: 8.0 Nm | | | -
Install the tire and balance the wheel. | | | -
Install the wheel and tire. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation). | | |
