Removal and Installation Removal NOTE:Removal steps in this procedure may contain installation details. | -
Refer to: Air Cleaner (303-12A Intake Air Distribution and Filtering - 2.0L Duratec-HE (MI4)/2.3L Duratec-HE (MI4), Removal and Installation). | | -
NOTE:Before removing the TCM, make certain that the selector lever is in the N position. | Installation | -
CAUTION:Make sure that the component is clean, free of foreign material and lubricant. | | -
CAUTION:Make sure that the terminals or pins/sockets of the transmission control module (TCM) and the TCM connector are not bent or damaged. CAUTION:The component must be aligned with the installation markings. NOTE:The new TCM is set in the N position at the factory Torque: 25 Nm | | -
To install reverse the removal procedure. | | -
Refer to: Selector Lever Cable Adjustment (307-05 Automatic Transmission/Transaxle External Controls - Vehicles With: 6-Speed Automatic Transmission (AWF21), General Procedures). | | -
NOTE:New units must be configured using the Programmable Module Installation Routine in the Worldwide Diagnostic System (WDS). | | |