| General Procedures | | -
A maximum of eight keyless entry remote transmitters can be programmed to the central junction box (CJB). Programming must be carried out at the same time for all the remote transmitters. | | | -
To enter programming mode, first make sure that the vehicle battery is fully charged and that the anti-theft system is not armed or triggered. | | | -
Make sure that the turn signal lamp switch is in the OFF position. | | | -
Fasten the safety belts and close all doors to make sure that conflicting chimes do not sound during programming. | | | -
The ignition switch must be turned to position II exactly four times during remote transmitter programming. Failure to follow this instruction may result in incorrect remote transmitter programming. | | | -
Turn the ignition switch from position I to position II four times exactly within six seconds. | | | -
Turn the ignition switch to position I. | | | -
An audible chime (only if an anti-theft system is installed) will be heard when the CJB has entered the learning mode. | | | -
Press and hold one of the buttons on the remote transmitter until a chime sounds. This indicates a new remote transmitter code has been successfully received. | | | -
After each successful programming, another 10 second learning mode is automatically entered, up to a maximum of eight times. | | | -
To program additional remote transmitters, repeat step 9. | | | -
The system will leave the learning mode after the ignition switch is turned to either position II or III, or if no new remote transmitter is programmed during the 10 seconds, or if eight remote transmitters have been programmed. | | | -
An incorrect programming procedure does not affect the stored codes. | | | -
After successful programming, only the new programmed remote transmitters will be accepted. | | | -
Test all the programmed remote transmitters, by activating and deactivating the locking/unlocking functions. | | |
