Taurus AWD V6-3.5L (2009)
-
Tighten to 40 Nm (30 lb-ft).
87. NOTICE: Do not allow the intermediate shaft to rotate while it is disconnected from the gear or damage to the clockspring may occur. If
there is evidence that the intermediate shaft has rotated, the clockspring must be removed and recentered. For additional information,
refer to Air Bag Systems.
NOTE: Align the index marks made during removal.
Install the steering intermediate shaft onto the steering gear and install a new bolt.
-
Tighten to 23 Nm (17 lb-ft).
88. Connect the transaxle control electrical connector.
89. Attach the transaxle control wire harness to the transaxle stud bolt.
90. Connect the hose to the power steering reservoir.
91. Install the oil level indicator.