Taurus X FWD V6-3.5L (2008)
Connect the exterior door handle actuating rod to the front door latch and close the yellow clip.
10. If equipped, connect the front door lock cylinder actuating rod to the front door lock cylinder pawl.
11. Install the 2 window glass clamp bolts.
-
Position the window in both the window clamps.
-
Shift the door window glass fully rearward.
-
Tighten to 8 Nm (71 lb-in).
12. Push the wiring harness grommet through the door module.
13. If equipped, connect the keyless entry keypad and front door disarm switch electrical connectors.
14. If equipped, connect the exterior mirror electrical connector.
15. Install the watershield.
16. Position the interior door handle and loosely install the bolt.
17. Install the front door trim panel.
18. Center the interior door handle alignment pins to the front door trim panel and install the interior door handle bolt.
-
Tighten to 7 Nm (62 lb-in).