| In-vehicle Repair Removal | | -
Disconnect the battery ground cable.
For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
| | | -
Slide open the bolt cover. | | | -
Remove the accessory drive belt shield retaining bolts. | | | -
Detach the fuel charging wiring harness and remove the accessory drive belt shield. | | | -
Remove the engine oil filler pipe. | | | -
Remove the intake manifold. | Installation | | -
NOTE:Inspect the intake manifold gaskets. Install new intake manifold gaskets if necessary. To install, reverse the removal procedure. | | |
 Diesel/Description and Operation/Diagnosis and Testing/In-vehicle Repair//img/E0014625.jpg)
 Diesel/Description and Operation/Diagnosis and Testing/In-vehicle Repair//img/E0013013.jpg)
 Diesel/Description and Operation/Diagnosis and Testing/In-vehicle Repair//img/E0014626.jpg)
 Diesel/Description and Operation/Diagnosis and Testing/In-vehicle Repair//img/E0013014.jpg)
 Diesel/Description and Operation/Diagnosis and Testing/In-vehicle Repair//img/E75765.jpg)
