Sprinter 2500 V6-3.0L DSL Turbo (2008)
11. Disconnect the return fuel hose from the injectors.
12. Disconnect the fuel injector and camshaft position sensor wiring harness connectors and set aside.
13. Remove the injectors.Â
14. Disconnect the heater hose bracket from the cylinder head cover.
15. Disconnect the vacuum pump supply hose pipe at the front of the cylinder head cover.
16. Remove the transmission tube (2) fastener at the engine cover bracket.
CAUTION: Care must be taken not to damage the cylinder head cover. If the sealant is difficult to separate, use a hand held heat gun and
warm the area thoroughly along the sealer bead.
NOTE: The rear camshaft seal in located inside the oil separator housing adaptor assembly.
17. Remove the cylinder head cover (3) and front seal (4).