Sprinter 2500 V6-3.0L DSL Turbo (2008)
8. Remove the screws (2) and remove the bezel (1).
Instrument Panel Cluster Bezel - Installation
INSTALLATION
WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, seat belt
tensioner, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two
minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the
airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury.
1. Install the bezel (1) and install the screws (2).
2. Install the ignition switch bezel (3), .
3. Install the steering column opening cover, .
4. Install the instrument cluster (2), See: Instrument Cluster - Installation.
5. Install the steering wheel (1), .
6. Instal the side air nozzles (1), .