Sprinter 2500 V6-3.0L DSL Turbo (2008)
Air Filter Element: Service and Repair
Removal
REMOVAL
NOTE: Housing removal is not necessary for element (filter) replacement.
1. Disconnect the negative battery cable.
2. Disconnect the mass air flow (MAF) (4) and air pressure sensor (3) electrical connectors.
3. Pry up 2 spring clips (1) from front of housing cover (2), (spring clips retain cover to housing).
4. Release housing cover (2) from locating tabs located on rear of housing, and lift cover.
5. Remove air cleaner element (2) from housing.
