Sprinter 2500 V6-3.0L DSL Turbo (2008)
Air Filter Element: Service and Repair
Installation
INSTALLATION
NOTE: Clean housing and inspect the gasket for damage before installing a clean filter. Replace as necessary.
1. Install element into housing (2).
2. Position housing cover into rear housing locating tabs (1) and seat cover onto housing.
3. Pry up spring clips (1) and lock cover to housing.
4. Connect air intake duct and tighten clamp to 5 N.m (44 in. lbs.).
5. Connect the MAF (4) and air pressure sensor (3) electrical connectors.
6. Connect the negative battery cable.