C 1500 Truck 2WD V8-4.8L VIN V (2000)
7. Install the new oil seal (2) using the J 39114-A.
8. Install the hub (3) to the axle housing (1).
Notice: Refer to Fastener Notice in Service Precautions.
9. Install the adjusting nut (4) to the hub (3).
Tighten the adjusting nut to 68 Nm (50 ft. lbs.).
10. Adjust the wheel bearings.
-
Refer to Wheel Bearing Adjustment. See: Adjustments
11. Install the key (5) to the hub (3).
12. Install the retaining ring (6) to the hub (3).
13. Install the brake rotor.
-
Refer to Brake Rotor Replacement - Rear in Brakes and Traction Control.
14. Install the axle shaft (1).
-
Refer to Axle Shaft Replacement (10.5 inch Ring Gear).
15. Install the tire and wheel assembly.
-
Refer to Tire and Wheel Removal and Installation In Steering and Suspension.
16. Remove the supports and lower the vehicle.