Canyon 2WD L5-3.5L VIN 6 (2004)
^
Tighten the brake hose bolt to 40 Nm (32 ft. lbs.).
3. Remove the plug or cap from the exposed brake pipe fitting.
4. Install the brake hose to the brake pipe.
Important Ensure that the brake hose is not twisted and does not come in contact with any of the suspension components.
5. Using a backup wrench on the brake pipe fitting, tighten the brake hose fitting.
^
Tighten the brake hose fitting to 19 Nm (14 ft. lbs.).
Important Ensure that the retaining clip is properly seated.
6. Install the new brake pipe retaining clip.
7. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure).
8. Install the tire and wheel assembly.
9. Lower the vehicle. Refer to Vehicle Lifting.