Workshop Repair Manuals

GMC Workshop Manuals

[PREV PAGE] [NEXT PAGE]

gmc Workshop Repair Guides


Savana 3500 V8-4.8L (2009)

Engine, Cooling and Exhaust > Engine > Engine Lubrication > Engine Oil Dip Stick - Dip Stick Tube > Component Information > Service and Repair > Oil Level Indicator Tube Replacement > Page 1877

Page 2
background image

1. Lubricate the O-ring seal (421) with clean engine oil.
2. Install a NEW O-ring seal onto the oil level indicator tube, if required.
3. Install the oil level indicator tube (420) between the exhaust manifold and engine block.
4. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle   (See: Maintenance/Vehicle Lifting/Service and Repair).
5. Insert the oil level indicator tube into the block.

The tube must be installed with the collar flush to the block.

6. Lower the vehicle.

Caution:  Refer to Fastener Caution   (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).

7. Install the oil level indicator tube bolt (419) and tighten to 25 Nm(18 lb ft).
8. Install the oil level indicator (418).
9. Position the coolant recovery reservoir and install the retaining bolt.

10. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement   (See: Tune-up and Engine Performance Checks/Air Cleaner

Housing/Service and Repair).

Engine, Cooling and Exhaust > Engine > Engine Lubrication > Engine Oil Dip Stick - Dip Stick Tube > Component Information > Service and Repair > Oil Level Indicator Tube Replacement > Page 1877

[PREV PAGE] [NEXT PAGE]