Accord L4-2.4L (2005)
4. Remove the C-pillar trim (A).
1. Pull the front edge of the trim down to detach the hooks (B) and clips (C) from the B-pillar upper trim (D).
2. Pull out the trim to detach the clips (E).
3. Pull out the bottom portion of the trim to detach the hooks (F) from the rear shelf (G) and the side trim panel (H).
4. Pass the rear seat belt (I) out through the slit in the trim.
5. Install the trim in the reverse order of removal, and note these items:
-
Check the clips for damage or stress-whitening, and replace them with new ones.
-
Push the clips and hooks into place securely.
-
Apply medium strength liquid thread lock to the anchor bolt before reinstallation
-
Before installing the anchor bolt, make sure there are no twists or kinks in the belt.
Special Tools Required
KTC trim tool set SOJATP2014
4-door-C-pillar - Without Side Curtain Airbags ('03-04 models)
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
1. Remove these items:
-
Rear seat side bolster
-
Rear door opening trim, as needed
2. Pull the C-pillar trim (A) back by hand to detach the clips, then remove it.
3. Install the trim in the reverse order of removal, and note these items:
-
Check the clips for damage or stress-whitening, and replace them with new ones.
-
Push the clips into place securely.
Special Tools Required
KTC trim tool set SOJATP2014
A-pillar - With Side Curtain Airbags ('04-06 models)
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.