S2000 L4-2.2L (2004)
2. Install the inboard joint (A) into the rear differential (B) by aligning the reference marks (C), then install the six inboard joint mounting bolts (D)
and nuts (E).
3. Install the knuckle (A) onto the lower arm (B). Be careful not to damage the ball joint boot (C). Wipe off the grease before tightening the nut at the
ball joint. Torque the castle nut (D) to the lower torque specification, then tighten it only far enough to align the slot with the pin hole. Do not align
the nut by loosening it.
4. Install the new cotter pin (E) into the pin hole, and bend the cotter pin.
5. Install the ABS sensor harness (A) on the upper arm.