S2000 L4-2.2L (2004)
15. Lift up the boot band tool to bend the free end of the band 90° to the clip. Center-punch the clip, then fold over the remaining tail onto the clip.
16. Unwind the boot band tool, and cut off the excess free end of the band to leave a 5 - 10 mm (0.2 - 0.4 inch) tail protruding from the clip.
17. Bend the band end (A) by tapping it down with a hammer.
NOTE:
^
Make sure the band and clip do not interfere with anything and the band does not move.
^
Remove any grease remaining on the surrounding surfaces.
Outboard Joint Side: