H2 V8-6.2L (2008)
Body Emblem: Service and Repair
Endgate Emblem/Nameplate Replacement
Endgate Emblem/Nameplate Replacement
Tools Required
J 25070 Heat Gun - 500-750F
Removal Procedure
Important: Use the tape for protection and alignment marks for alignment of the new emblem.
1. Apply tape to the area around the endgate emblem.
2. Heat the emblem/nameplate, using a heat gun J 25070 152 mm (6.0 in) from the surface.
3. Apply the heat using a circular motion for about 30 seconds.
Notice: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.
4. Remove the emblem/nameplate from the endgate surface using a flat-bladed plastic tool.
5. Remove all adhesive from the endgate panel surface and the back of the emblem/nameplate using 3M(TM) scotch brite molding adhesive remover
disk 3M(TM) P/N 07501 or equivalent.
6. Clean the endgate surface using varnish makers and painters (VMP) naptha.
Installation Procedure
