H2 V8-6.2L (2008)
1. If the location of the emblem/nameplate has not been marked apply tape.
2. Warm the endgate surface with a heat gun J 25070 152 mm (6.0 in) from the surface to a minimum of 21°C (70°F).
Important: Do not touch the adhesive backing of the emblem/nameplate.
3. Remove the backing from the front end of the emblem/nameplate.
4. Press the emblem/nameplate to the endgate panel surface while continuing to remove the backing.
5. Hand roll the emblem/nameplate to the endgate panel to ensure proper adhesion.
6. Inspect the emblem/nameplate for bonding.
7. Remove the tape from the area around the endgate emblem.
