H2 V8-6.2L (2008)
10.
Install the plastic extrusions strip to the lip of the quarter panel (left and right). Remove the tape strip and install the lip. Install the clips as seen in
the illustration above.
11.
Install the pencil brace and metal bumper filler.
Tighten
Tighten the bolts to 32 N.m (24 lb ft).
12.
Install the bumper corner cap.
13.
Install the push pins.
14.
Install the parking lamp into the corner cap.
15.
Install the parking lamp wire harness and two 10 mm nuts to the parking lamp.
Tighten
Tighten the nuts to 6 N.m (53 lb in).
16.
Reposition the wheelhouse liner and install the 10 mm bolt.
17.
Install the bumper center cover.
18.
Install the spare tire latch.
Tighten
Tighten the bolts to 32 N.m (24 lb ft).
Parts Information
Warranty Information
Disclaimer
