H2 V8-6.2L (2008)
Important: Install the retainer plate with the sealing gasket facing the engine block.
The gasket surface on the engine block should be clean and free of dirt and/or debris.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
5. Install the camshaft retainer and bolts.
Tighten the camshaft retainer bolts to 25 N.m (18 lb ft).
6. Inspect the camshaft sensor O-ring seal. If the O-ring seal is not cut or damaged, it may be reused.
7. Lubricate the O-ring seal with clean engine oil.
8. Install the camshaft sensor and bolt.
Tighten the camshaft sensor bolt to 25 N.m (18 lb ft).
9. Install the camshaft sprocket and timing chain. Refer to Timing Chain and Sprocket Replacement (See: Timing Components/Timing
Chain/Service and Repair) .
10. Install the engine front cover. Refer to Engine Front Cover Removal (See: Service and Repair/Overhaul/Disassembly/Engine Front Cover
Removal) .
11. Install the valve lifters. Refer to Valve Lifter Replacement (See: Lifter / Lash Adjuster/Service and Repair) .
12. Install the radiator support. Refer to Radiator Support Replacement () .
13. Install the hood. Refer to Hood Replacement (See: Body and Frame/Doors, Hood and Trunk/Hood/Service and Repair/Hood Replacement) .
14. Lower the hood to the normal position.
